TROUBLESHOOTING
If these solutions do not solve the problem, contact an authorised service centre.
Problem
Possible cause
Solution
The product does not
start.
The battery charge is low.
Charge the battery.
The charger is connected to the product.
Disconnect the charger from product.
The start key is not installed or is in the OFF
position.
Insert the start key, and turn it to the ON position.
Poor battery cable connections
Check and clean all the battery connections.
The product does not
move.
The start key is not installed or is in the OFF
position.
Insert the start key, and turn to the ON position.
The joystick is not pulled up.
Pull up the joystick.
The joystick is in the neutral position.
Move the joystick in the preferred direction (forward or reverse).
The brake is pressed and/or the parking
brake is engaged.
Release the brake pedal and the parking brake, then set the
joystick in the neutral position to reset the product.
The charger is connected to the product.
Disconnect the charger from the product.
The operator is not fully seated.
Sit down fully on the seat, return the joystick to the neutral
position, and try again.
The product is cutting
grass unevenly.
The tyre pressure is uneven.
Check the tyre pressure in all four tyres.
The mower deck is not level.
Perform cutting deck level adjustment.
The blade is worn, bent, loose, or dull.
Replace the blade.
There is buildup of debris under the product.
Clean the underside of the mower deck.
The mowing speed is too fast.
Mow at a slower speed.
The product is not
mulching properly.
There are wet grass clippings sticking to the
underside of the deck.
Wait until the grass dries before mowing.
The grass is too high.
Mow once at a high cutting height, then mow again at the
preferred height.
The blade is worn, bent, loose, or dull.
Replace the blade.
The mowing speed is too fast.
Mow at a slower speed.
The product is
vibrating at a higher
speed.
The blade is unbalanced, loose, or
excessively or unevenly worn.
Replace the blade.
The motor shaft is bent.
Turn off the product, and remove the start key. Inspect the product
for damage. Have the product serviced by an authorised service
centre before restarting.
Summary of Contents for R80XZTR54
