Ryobi ONE+ P742ID, Operator'S Manual

Page: 5 / 29

5 — English
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to pos-
sible serious personal injury.
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
ASSEMBLY
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove the battery pack from the product when
you are assembling parts, cleaning, or when not in use.
Removing these energy sources will prevent accidental
starting that could cause serious personal injury.
WARNING:
The radio is not waterproof. Do not submerge in liquid.
Failure to heed this warning could result in serious per-
sonal injury.
NOTICE:
Always refer to the manual for any device recommended
for use as an attachment or accessory. Proper use of any
device, when attached to the radio, is the sole respon-
sibility of the operator. Improper use may damage the
device or the product.
WARNING:
This radio is capable of producing sound levels that can
be dangerous to long-term hearing. Listening to music
at high volume for any period of time can cause noise-
induced hearing loss. The higher the volume, the less time
required before your hearing could be affected.
APPLICATIONS
You may use this product for the following purposes:

Listening to FM/AM radio, MP3 players, and other audio
devices

Charging USB capable devices

Streaming audio from BLUETOOTH
®
enabled devices
INSTALLING/REMOVING AAA BATTERIES
See Figure 1, page 9.
It is advisable to write down saved channels before replacing
the AAA batteries.
There is a 15-second time frame for replacing the AAA bat-
teries. If the batteries are not replaced within 15 seconds,
the radio will lose all settings previously stored in memory,
and they will require reprogramming.
Always use new alkaline batteries for replacement.
WARNING:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.

Remove the battery pack, if installed.

Loosen the screw in the battery door. Remove door and
set aside.

Install two new AAA batteries according to polarity indica-
tors inside the battery compartment.
NOTE:
Do not mix old and new batteries. Do not mix
alkaline, standard (carbon-zinc), or rechargeable (nickel-
cadmium) batteries.

Replace the battery door and tighten screw to secure.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 9.
To install battery pack:

Place the battery pack in the radio, aligning the rib on the
battery pack with the groove in the battery port.

Make sure the latches on the battery pack snap into
place and the battery pack is secured to the radio before
beginning operation.
OPERATION