7 — English
FEATURES
PRODUCT SPECIFICATIONS
Switch .............................................. Two Speed/Reversible
No Load Speed .................................200/600 r/min. (RPM)
Torque .................................................................... 45 in. lb.
Handle Positions ............................................................... 2
Charger Input.....................................120 V, AC only, 60 Hz
Charge Rate ...................................................... 9–12 hours
ASSEMBLY
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to pos-
sible serious personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance. In Mexico, please call 01-800-843-1111.
OPERATION
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
Driving screws with screwdriver bits
Light-duty drilling
TO CHARGE
See Figure 1, page 10.
When charging the screwdriver, a red charge light will
Illuminate solid on the handle of the screwdriver. This red
charge light will go off when the screwdriver is fully charged.
Insert charger plug into input jack making sure it is
properly connected.
Charger can be used with normal household current of
120 V, AC only, 60 Hz.
Connect charger to power supply.
After normal usage, a minimum of 9 hours of charging
time is required to fully recharge the screwdriver.
Do not
place charger in an area of extreme heat or cold.
It will work best at normal room temperature.
Remove the product from the charger once it is fully
charged and ready for use.
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be locked when not
in use or carrying at your side.
