11 - English
OPERATION
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
WARNING:
To prevent the workpiece or the backup material from
being torn from your hand while drilling, position them
against the left side of the column. If the workpiece or
the backup material are not long enough to reach the
column, clamp them to the table. Failure to do this could
result in personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
Drilling in wood
Drilling in ceramics, plastics, fiberglass, and laminates
Drilling in metals
POWER SWITCH
See Figure 14, page 19.
The drill press is equipped with a power switch that has a
built-in locking feature. This feature is intended to prevent
unauthorized and possible hazardous use by children and
others.
To turn the drill press on:
With the switch key inserted into the switch, lift the switch
to turn
ON ( l )
.
To turn the drill press off:
With the switch key inserted into the switch, push the
switch down to turn
OFF ( O )
.
To LOCK the drill press:
Place the switch in the
OFF ( O )
position.
Remove the switch key from the switch and store in a
secure location.
WARNING:
ALWAYS remove the switch key when the tool is not in
use and keep it in a safe place. In the event of a power
failure, turn the switch
OFF ( O )
and remove the key.
This action will prevent the tool from accidentally starting
when power returns.
WARNING:
Always make sure the workpiece is not in contact with the
bit before operating the switch to start the tool. Failure
to heed this warning may cause the workpiece to be
kicked back toward the operator and result in serious
personal injury.
SELF-EJECTING CHUCK KEY
See Figure 15, page 20.
The self-ejecting chuck key ensures the chuck key is removed
from the chuck before the drill press is turned on.
In order to loosen or tighten the chuck using the chuck key,
push the key into the key hole located on the chuck. Rotate
the key clockwise to tighten the chuck or counterclockwise
to loosen the chuck.
WARNING:
Use only the self-ejecting chuck key provided. Always
remove chuck key. Failure to heed this warning could
result in serious personal injury.
TABLE ROTATION
See Figure 16, page 20.
The table can be rotated out of the way when drilling large
objects.
Loosen the table lock handle.
Rotate the table to the desired position.
Retighten the table lock handle.
INSTALLING AND REMOVING BITS
See Figure 17, page 20.
Unplug the drill press.
Open or close the chuck jaws to a point where the opening
is slightly larger than the bit size you intend to use.
Insert drill bit into the chuck the full length of the jaws.
Summary of Contents for DP103L
Page 50: ...NOTES NOTAS...
Page 51: ...NOTES NOTAS...
