9
English (Original Instructions)
SPOOL REPLACEMENT
See Figure 15.
Use original manufacturer's replacement spool.
Remove the battery pack.
Push in tabs on side of spool retainer.
Pull spool retainer up to remove.
Remove the old spool.
To install the new spool, make sure the line is captured
in the slot on the new spool. Make sure the end of the
line is extended approximately 15cm. beyond the slot.
Install the new spool so that the line and slot align with
the eyelet in the cutting head. Thread the line into the
eyelet.
Pull the line extending from the cutting head so the line
releases from the slot in the spool.
Reinstall the spool retainer by depressing tabs into
slots and pushing down until spool retainer clicks into
place.
LINE REPLACEMENT
See Figure 15-16.
Use only round type 1.65mm monofilament line.
Remove the battery pack.
Remove the spool from the cutting head.
NOTE:
Remove any old line remaining on the spool.
Cut a piece of line approximately 2.7m long. Use only
1.65mm monofilament line.
Insert the line into the anchor hole in the upper part
of the spool. Wind the line around the upper part of
the spool clockwise, as shown by the arrows on the
spool. Place line in the slot on upper spool flange,
leaving about 15cm extended beyond the slot. Do not
overfill. After winding the line, there should be at least
6mm between the wound line and the outside edge
of the spool.
Replace the plastic retainer, spool, and the spool
retainer. Refer to Spool Replacement earlier in this
manual.
STORING THE TRIMMER
Remove the battery pack from the line trimmer before
storing.
Clean all foreign material from the trimmer.
Store it in a place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
