10
English (Original Instructions)
PROBLEM
POSSIBLE CAUSE
SOLUTION
Line will not advance when
using the auto-feed head:
Line is welded to itself.
Lubricate with silicone spray.
Not enough line on spool.
Install more line. Refer to Line replacement
earlier in this manual.
Line is worn too short.
Pull line while pressing button.
Line is tangled on spool.
Remove line from spool and rewind. Refer
to
Line Replacement
earlier in this manual.
Grass wraps around boom
housing and cutting head
Cutting tall grass at ground
level.
Cut tall grass from the top down to prevent
wrapping.
Motor fails to start when switch
trigger is depressed.
Battery is not secure.
To secure the battery pack, make sure the
latches on each side of the battery pack
snap into place.
Battery is not charged.
Charge the battery pack according to the
instructions included with your model.