Ryobi A32BR01, Operator'S Manual

Page: 5 / 20

5 — English
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 7.

Insert the battery pack into the battery port.

Make sure the latches on each side of the battery pack
snap into place and that the battery pack is secured in
the hand vac before beginning operation.

Locate the latches on the side of the battery pack and
depress both sides to release the battery pack from the
hand vac.
For complete charging instructions, see the operator’s manu-
als for your battery pack and charger.
STARTING/STOPPING THE VACUUM
See Figure 2, page 7.

To start the vacuum: Depress the ON/OFF switch to turn
the vacuum on.

To stop the vacuum:
Depress the ON/OFF switch to turn
the vacuum off.
INSTALLING ACCESSORIES
See Figure 3, page 7.
Install only accessories designed for use with this vacuum.


Remove the battery pack.

Insert the accessory onto the nozzle.

Push the accessory securely into place.

When not in use, remove and store the accessory.
USING THE MINI BEATER BAR
See Figure 4, page 7.
The mini beater bar can connect directly to the vacuum for
cleaning upholstery and stairs.
To connect:

Switch off unit and remove the battery pack.
 Align the pins on the mini beater bar with the receptacle
in the vacuum.

Press into place.
 Replace battery pack.
To remove:
 Switch off unit and remove the battery pack.

Pull to remove.
OPERATION
REMOVING/REATTACHING THE DUST BOWL
See Figures 5 - 7, page 8.
The dust bowl should be checked, emptied, and cleaned
periodically for maximum dust collection.
To empty:


Remove the battery pack.


Press the locking tab on the bottom of the bowl to release
the spring loaded door.


Hold unit over waste receptacle.


Shake lightly or tap sides to dislodge debris.


Close door, pressing firmly until lock button engages.
To remove:


Remove the battery pack.


Depress the release button located on the nozzle. Pull
the dust bowl down and out.
To reattach:

Position the two sections as shown.

Align the slot on the bottom of the dust bowl and the
eject tab at the front of the dust bowl.
NOTE: Make sure tab and slot are aligned correctly before
securing the dust bowl.

Press the dust bowl into place until you hear a click.