Rush STROBE 1 5x5, User Manual

Page: 12 / 44

RUSH STROBE 1 5x5 user manual 12
wrench (Allen key). Place the two fixtures to be attached side-by-side, and
extend the hooks to connect them.
Mounting on a truss
An individual fixture or array can be clamped to a truss or similar rigging
structure. When clamping to a truss:
1. Check that the rigging structure can support at least 10 times the weight of
all fixtures and equipment to be installed on it.
2. Block access under the work area.
3. Rig the fixture or array using clamps and hardware suitable for the
purpose. Fasten them to the screw holes in the fixture bracket. Working
from a stable platform, hang the fixture on the truss. Tighten the rigging
clamps and hardware.
4. Secure each and every fixture against clamp failure with a secondary
attachment such as a safety cable that is passed through the safety cable
mounting point on the rear of the fixture. Secondary attachments must be
approved for the weight of the fixture and fastened to the load bearing
structure,
not to an adjacent fixture!