EN
8
Fuel blending shall only be done with RURIS 2TT-MAX oil or an oil of API classification:
TC or higher, use a mixture of 25 ml oil to 1 litre unleaded petrol using an impurity free
container.
The movement of the container is necessary to homogenise the fuel with the oil.
3.
Ga oil mixing is not done directly in the tank.
4.
Make sure there is enough fuel in the tank.
5.
The throttle is fully engaged and locked in this position.
6.
The on-off switch is in the 'ON' position.
7.
All motor pump screws are firmly tightened.
Running-in period
Running-in should be done in light load (pumping water), three tanks of petrol. At intervals
of 10-15 min accelerate to full throttle for 10-15 sec to evacuate unburned oil from the
muffler.
2.1 Starting the engine
●
place the pump in a horizontal position on the ground
●
prime the carburettor with petrol by 3 successive presses of the petrol pump
●
throttle lever and switch are correctly positioned for starting
●
position the shock flap to the closed position as shown in the figure above
●
full throttle
●
with your left hand, secure the motor pump firmly and with your right hand pull
the starter rope
●
The rope must be pulled in two steps. The first step shall be made by gently
pulling the starter until the rope is pre-tensioned and out of the starter roll about
Summary of Contents for MP30
