Main Support no.: +370 5 2045030
Polish Support no.: +48 22 2092532
Ukrainian Support no.: +380 947 107319
29
www.ruptela.com
Conditions for device wake up from sleep mode:
A High priority event is triggered;
The c
onfigured engine state changes to “ON”;
The Sleep timer IO configured time is reached.
When
Custom
is selected you can choose, which functionalities
should work during device sleep and which functionalities
should be disabled. Like previously, it is possible to set a timeout. Once the set timeout passes, the device
will switch to
Custom
sleep mode. The full functionality description can be found on our documentation
With
Data sending
settings you can configure the data sending frequency and conditions.
The
Enable
checkbox must be enabled.
Min. records
–
the minimum number of records required to establish a connection to the
server. If the device detects less records than the entered value, the link to the server will not
be opened.
Period
–
sets how often the device will check for the required number of records.
Link timeout
–
this value indicates how long the device should wait before closing the link,
after the link was successfully established with the server and all the records had been sent.
The default value is 7 seconds, it is recommended not to change it.
Link settings
contain the following settings:
The
Constant link
checkbox forces the FM device
to check the server link state and keep it “alive” all
the time. If the server or network closes the link,
the device automatically reopens it but does not
send any packets.
The
TCP Keep alive
checkbox if enabled will send
“keep alive packets” every minute if there is no
data being sent. Therefore, the device is always
accessible via GPRS.
(requires the use of the
TCP protocol)
Heartbeat
–
is a special function that sends a
heartbeat packet
–
GPRS command 16/116 after
the set time period has passed
since the last
packet sent.
Which means that if the device is
constantly sending packets, the heartbeat packet
will not be sent. As the name explains, this
function is used to keep an open socket on the
server side if no other packets are sent.
Notes
If the constant TCP link functionality is enabled, the device ignores the link timeout parameter for
the main connection and uses it only for emergency connections.
The constant TCP link and Heartbeat functionalities do not work with the second server if
Two
Servers
mode is used.
Timetable
allows you to select particular days and hours for the
data to be sent at.
