Rupes LHR 15E, Original Operating And Maintenance Instructions

Page: 8 / 34

8
TECHNICAL DATA ENGLISH
TYPE LHR15E LHR21E
PROTECTION CLASS II II
OPERATING VOLTAGE 230 V - 50 Hz 230 V - 50 Hz
ABSORBED CURRENT 4,3A 5,3A
ABSORBED POWER 900W 1100W
ELECTRONIC SPEED CONTROL YES YES
ROTATION RPM 1500÷4000 2000÷4500
PAD FIXING THREAD M8 M8
PAD DIAMETER mm 150 150
BUFFER PAD DIAMETER MAX mm 180 180
PAD TYPE VELCRO FACED VELCRO FACED
WEIGHT Kg 1,850 1,950
The safety and accident prevention instructions are reported in the “SAFETY
INSTRUCTION” booklet which forms an integral part of these documents; the
operating instructions indicate the additional information required specifically
for use of the tool.
SAFETY AND ACCIDENT PREVENTION INSTRUCTIONS
This electrical tool is designed to be used as a grinder. Read all the warnings,
instructions, indications provided on drawings and specifications supplied
with this electrical tool.
Failure to comply with all the instructions provided below may cause electrical
shocks, fires and/or serious injuries.
This tool is not intended to be used for smoothing, metal brushing, polishing
and cutting operations.
The use of this tool for unintended applications may cause hazards and injuries to
people.
The tool must be used with accessories that have been specifically designed
or recommended by the manufacturer.
The fixing of the accessory to the tool does not guarantee a safe operation.
T
he rated speed of the accessory must be at least equivalent to the maximum
GENERAL WARNINGS
speed specified on the electrical tool.
Using the accessories at speeds above the rated one may cause them to break or
be projected into the air.
The external diameter and thickness of the accessory must match the
specifications of the electrical tool.
Accessories with incorrect dimensions cannot be adequately protected or
controlled.
The configuration of grinding wheels, flanges, support pads or any other
accessory must match the electrical tool.
The use of accessories that cannot be perfectly fitted on the electrical tool may
result in imbalance, excessive vibrations and in the impossibility of controlling the
tool.
Do not use damaged accessories. Before use, inspect all the accessories.
Inspect the abrasive grinding wheels and verify that there are no splits or
cracks. Inspect the supporting pads and verify there are no cracks, tears or
excessive wear. Inspect the metal brushes and verify that there are no loose
or broken wires. If the electrical tool or accessory has fallen, verify that it is
not damaged or install a new accessory. After inspecting or installing an ac-
cessory, test the operation of the tool at maximum speed and without load for
one minute, keeping at a safety distance.
If the accessories are damaged, they
will break during this test..
8