Operation
70
Runco X-200i Series Installation/Operation Manual
PRE
L
IMINAR
Y
Control
Select Control from the Main Menu to set various options related to control of the
projector.
Trigger 1:
Select Trigger 1 from the Control menu to specify when the Trigger 1 port
outputs 12 volts. There is a three-second delay before activation to prevent operation
while selecting an aspect ratio.
•
Auto
S
cope
causes the port to output 12 volts whenever the the Cinema or Virtual
Cinema aspect ratio is active.
•
Lamp
causes the port to output 12 volts whenever the lamp is on.
•
4:3
causes the port to output 12 volts whenever the 4:3 aspect ratio is chosen. The
output stops if PIP is enabled (PIP source is set to anything other than off).
•
R
S
232
causes the port to output 12 volts when an RS232 screen trigger 1 “on”
command is received and stop when a trigger 1 “off” command is received. The 12 volt
output also stops when the projector is turned off.
Trigger 2:
Select Trigger 2 from the Control menu to configure the Trigger 2 output.
Trigger 2 operates identically to Trigger 1.
CineWide:
Select CineWide from the Control menu and set it according to the installed
lens configuration, as follows:
• For a standard X-200i (no anamorphic lens), choose
Off
.
• For a X-200i with a fixed anamorphic lens, choose
CineWide
.
• For a X-200i with a movable anamorphic lens, choose
Auto
S
cope
.
Auto
S
ource:
This control chooses whether or not to scan for other active sources if the
current source is not available. The default setting is
Off
.
➤
