Installation
Runco X-200i Series Installation/Operation Manual
15
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the X-200i installation process. The sections following
this one provide detailed instructions.
Installation
must
be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
S
tep
Procedure
For Details, Refer
to page...
1
Choose a location for the projector
16
2
Install CineWide lens mounting assembly (stationary base plate or
AutoScope lens motor – optional)
23
3
Mount the projector
28
4
Connect signal sources to the X-200i
30
5
Connect external controller to RS-232 port; connect IR repeater
system to wired remote input (optional)
33
6
Connect 12-volt trigger output to retractable screen or other,
+12V trigger-activated equipment (optional)
34
7
Connect the Active 3D Emitter to the projector
35
8
Apply power to the projector
35
9
Primary lens adjustments: projected image size (zoom), position
(shift) and focus
19, 37
10
Change the OSD Language (optional)
38
11
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation
39
12
Install and adjust secondary anamorphic lens (optional)
39
13
Projector calibration: adjust the following
for each input
; save
settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position
52
14
Prepare Active 3D Glasses for use and test with 3D source mate-
rial
73
Note
