Operation
50
Runco LS-3/LS-5 Installation/Operation Manual
PRE
L
IMINAR
Y
The default source selection is
HDMI 1
. All sources that are not available per the source
enable function (refer to
Source Enable
on page 58) are grayed out.
Figure 4-7. Source Select Sub-Menu
PIP Select:
To select a PIP (secondary) video source, press
or
to highlight PIP
Select, then press
ENTER
. The default PIP selection is
Off
.
All sources that are not available per the source enable function (refer to
Source Enable
on page 58) are grayed out.
All sources that cannot be used for PIP due to a shared electronic path with the Active
source are grayed out. The PIP source is a saved setting for each source, like brightness
and contrast.
If for some reason the current PIP source becomes invalid (by disabling it in the source
enable menu, for instance), PIP Select automatically resets to
Off
.
Resync:
If the projected image becomes unstable or degraded, press
or
to highlight
Resync, then press
ENTER
. This causes a re-acquisition of the active source and the PIP
source, if present. It also changes any Fine Sync settings (described on page page 55) for
this timing to the default setting.
Summary of Contents for LightStyle LS-3
