Runco LightStyle LS-12d, Installation & Operation Manual

Page: 66 / 152

Installation
50 LightStyle™ LS-12d Installation/Operation Manual
PRE
L
IMINAR
Y
3.8
Turning on the Power 1. Power up your source components.
2. Turn on the main power switch at the rear of the Dimension Digital Controller.
3. Press the ON button on the remote control (or the ON/ S TANDBY ( ) button on the
Dimension Digital Controller front panel) to turn on the system. The vacuum
fluorescent display on the Dimension Digital Controller front panel briefly displays
“Initializing System,” followed by “Starting LS-12d.”
4. When the display is ready for use, the fluorescent display indicates the active source,
input resolution/frame rate and aspect ratio/screen; for example:
5. When the projector is turned on, the Active 3D
Emitter turns on as well. The LEDs display a red
moving pattern while the emitter is attempting to
acquire a 3D signal and until a signal is found.
If the emitter searches for a signal for longer than
60 seconds, a signal is assumed to not be
present.
6. Upon finding a 3D signal, all LEDs will turn green.
Once the LEDs indicate a 3D signal, the Runco 3D
glasses can be used to experience 3D. For more
information on using the Runco Active 3D
Glasses, refer to
Using the Runco 3D Glasses
on page 94.
HDMI 1
16:9/1 1080i/60
Current
S ource
A s pect Ratio/ S creen Input Re s olution/Frame Rate
LS-12d
1080p/60
S earching for 3D S ync S ignal
3D S ync S ignal Found