Runco LightStyle LS-12d, Installation & Operation Manual

Page: 111 / 152

Operation
LightStyle™ LS-12d Installation/Operation Manual 95
PRE
L
IMINAR
Y
Power Button and Battery
Charge Indicator The top of the left earpiece of
the frames contains a button.
Inside the left earpiece is a red
LED.
Press and hold the Power button until the red LED comes on, then release the button. The
LED will then blink in a pattern that indicates the battery charge state. In general, the more
slowly and less frequently the LED blinks, the more charged (and less in need of charge)
the glasses are. Refer to Table 4-5.
If you charge the glasses while they are powered off, the LED displays a slow “heartbeat”
signal when the glasses are fully charged.
Turning Off the 3D
Glasses To turn the glasses off, press and hold the Power button. When the LED turns on (after
approximately one second), release the Power button. When you do, the LED blinks to
indicate the battery charge state as described in Table 4-5 and the glasses turn off.
Auto Power-Off If the glasses do not detect an emitter, the LED blinks on and off once per second for one
minute. Then, to preserve battery life, the glasses automatically turn off. If the emitter is
activated (the emitter is only active when the projector is in 3D mode) before the
one-minute period ends, the glasses stop blinking and remain on.
If the glasses automatically turn off, press the Power button to turn them back on.
Table 4-5. Battery Charge S tate Indication s
Blink Activity After
Power-on
Battery Charge S tate
Two (2) slow blinks Battery is 50% or more charged; 20 hours or more remaining.
Six (6) medium blinks Battery is 10% or more charged; 4 hours or more remaining.
12 fast blinks Battery charge is 10% or less; less than 4 hours remaining.
None Glasses must be charged before further use.
Power/Battery Charge
Indicator
Power Button
Battery Charging
Connector