rulmeca RDR BL3, Technical Manual

Page: 6 / 40

TECHNICAL MANUAL FOR THE RDR BL3 - V1.1 DRIVE ROLLER Rev. 21/09/2018 page 6
2 NEAR THE CONVEYOR HAZARDS
2.1 Personal injury
All the maintenance and repair work on the machine housing the RDR product must be performed only by qualified
and authorized persons in strict compliance with current regulations.
Before starting up the system, make sure that no unauthorized persons are near the conveyor. Any presences
must be known and there must be no misunderstandings or difficulties in immediate communication.
Electrical installation and maintenance work must be performed only after electrical current has been disconnected
and locked out and electrical discharges have been eliminated.
Make sure, during maintenance and/or installation, that it is not possible to unintentionally start parts that are able
to cause the conveyor to move (including the Drive Rollers).
When working on the conveyors (whether assembling or maintaining them), all the required personal protective
equipment (PPE) must be worn to avoid possible accidents.
The customer is solely responsible for making the workplace safe. Rulli Rulmeca S.p.A. and its subsidiaries are
not liable for any accidents or damage caused by carelessness or failure to comply with the instructions in this
manual.
2.2 Faults
Check the
RDR BL3
product regularly for visible damage that is visible to the naked eye.
If smoke or strange noises come from the Drive Roller or components splined on or connected to it, stop the
conveyor immediately and make the system safe. Inform the qualified personnel and assigned workers
immediately in order to identify the cause of the problem and fix it.
2.3 Prohibitions
It is explicitly forbidden to tamper with any part of the RDR BL3 product (unless agreed beforehand with Rulmeca).
It is forbidden to dismantle the product. Dismantling the product (or part of it) and removing the product by breaking
its parts voids the warranty.
Do not dump the product when it comes to the end of its life, comply strictly with the waste disposal regulations in
force in the country in which it is disposed of.
2.4 Installing the product in complex systems
The
RDR BL3
product can be installed in conveyors that are part of complex logistic systems and logics.
This technical manual refers only to the RDR BL3 product.
Consult the system documentation drawn up by the conveyor manufacturer to understand the general hazard
points.
It is the customer's responsibility to draw up the specific machine documentation and certification that
are required by the regulations of the country in which the conveyor is going to be used.