Ruijie RG-S6120 Series, Hardware Installation And Reference Manual

Page: 8 / 68

Ruijie RG-S6120 Series Switches Hardware Installation and Reference Guide
External Ports
The RG-S6120-48XS8CQ switch provides the following ports:

Universal serial bus (USB) port: This port can connect with USB memory to save logs, host versions, warnings
and other diagnostic messages. Therefore, it is more convenient to upgrade the software version of the switch on
line and save the log information.
To protect the data and avoid device damage, use qualified USB flash disks of good brands. At the same time, the
local USB port is compatible with most of the USB controllers except some USB flash disks.
The RG-S6120-48XS8CQ switch supports debugging, configuration, maintenance, management and host
software uploading of Console ports.

Console port: Use RS-232 interface electrical level and standard RJ45 connector. This interface is connected with
the serial port of terminal PC to perform system debugging, configuration, maintenance, management, and host
software uploading.

MGMT port: This is an out-band Ethernet port, which uses standard RJ45 connector. This interface is connected
with Ethernet port of a PC to perform program downloading.

SFP+ port: There are 48 10G SFP+ ports, which support optical modules and DAC copper cables, and are
compatible with 1000BASE-X.

QSFP28 port: There are eight 100G QSFP28 ports, which support 100G QSFP28 modules, 40G QSFP28
modules and DAC copper cables. The port can work in 4x25G mode.
Indicator
Indicator
Identificatio
n on the
panel
Status Meaning
System indicator
(Front panel/rear panel)
Status
Off The system is powered off.
Solid red
1
）
One of the modules of the system fails.
2
）
There are less than 3 fans.
3
）
The internal or partial temperature exceeds the
temperature limit, and the switching service
resets.
Blinking green Initialization is in progress.
Solid green The system works properly.
Solid yellow
1
）
The temperature reaches the warning threshold.
2
）
Only 3 fans are in the position.
3
）
One of the dual powers is not connected with the
AC power cord.
MGMT port indicator MGMT
Off The MGMT port is NOT connected.
Green
The MGMT port is connected at
1000M/100M/10Mbps.
Blinking yellow The MGMT port is transmitting or receiving data.
Locator indicator ID
Off
The locator is controlled by CPLD by default.
Solid blue
The locator is controlled by O&M personnel remotely.