Ruijie RG-S6120 Series Switches Hardware Installation and Reference Guide
Installing a RG-PA150I-F Power Module
1)
Take a new power module out of the package and confirm the input mode and the input parameters of the power
module match the requirements.
2)
Remove the blank panel and take the plane printed with power information as the top panel of the power module.
Hold the handle of the power module with one hand, and hold the end of the power module with the other hand.
Insert it into the chassis along the guide rail uprightly and slowly until it clicks into place, and make sure that it is in
good contact with the power slot.
Figure 3-11 Installing a Power Module
Insert the power module smoothly. Please pay attention to the direction of the power panel to avoid wrong
insertion.
If it is difficult or even impossible to insert the module, pull out the module, make sure the power module and guide
rail are well aligned, and then insert the module again.
Removing a RG-PA150I-F Power Module
1)
Press the plug of the power module, Hold on to the module handle with one hand to pull out part of the module,
hold the bottom of it with the other hand, and pull out the power module uprightly and slowly.
2)
Install a blank panel in the power module slot and put the removed power module into its package.
Figure 3-12 Removing a Power Module
