Hardware Installation and Reference Guide
Router Startup and Configuration
Before powering on the router, check the position of the power switch so that you may cut power supply in
time in case of accident.
Powering on Router
Turn the router to the power on position.
Check after Powering on
After powering on the router, please check:
If the ventilating system is normal.
When the router is powered on, you will hear the fan working. Put your hand near the air vent hole, you will feel
the movement of air.
If the indicators on the front panel of the router are operating normally.
If the Power, Fan, and System indicators all light up green, it means everything is right. If one of them lights up red,
it indicates that there is a fault.
If the configuration terminal displays correctly.
When the router is powered on, information on router software self-decompression will appear on the terminal
display.
Starting Process
When the router is started for the first time, the following information appears:
***********************************************
System bootstrap ...
Boot Version: RGOS 10.4(3), Release(105464)
Nor Flash ID: 0x01490000, SIZE: 2097152Bytes
CLOCK-3-HW_CAL_INVALID: Hardware Calendar (RTC) Error
MTD_DRIVER-5-MTD_NAND_FOUND: 1 NAND chips(chip size : 536870912) detected
MTD_DRIVER-5-MTD_NAND_FOUND: 1 nand chip(s) found on the target.
Waiting for subcard to initialize ..................
Press Ctrl+C to enter Boot......
Load program file: [flash/rgos.bin]
[OK]
Executing program, launch at: 0x01800000
CLOCK-3-HW_CAL_INVALID: Hardware Calendar (RTC) Error.
MTD_DRIVER-5-MTD_NAND_FOUND: 1 NAND chips(chip size : 536870912) detected
MTD_DRIVER-5-MTD_NAND_FOUND: 1 nand chip(s) found on the target.
Self decompressing the image:
