Hardware Installation and Reference Guide
Router Installation
Removing Router Power Module
This part deals with the removal of the RSR30 series routers. The module to be installed is the
RG-PA240R power module.
1)
Place the router in such a way that you face the rear panel of its host.
2)
Switch off the power module to be removed and leave the switches of other power modules on.
3)
Separate the fastening screw on the power module from the rear panel of the host by loosening it with a cross
screwdriver. Pull the power module out of the host and remove it from the host cabinet.
Before removing the power module, make sure that the AC switch on it is switched off and the AC power
cable is disconnected with the AC power socket. Otherwise, electric shock or damage to the router may
result.
In Step 3 be careful and pull the power module out gently and smoothly. If you find the module hard to pull
out, never pull it hard. Instead check whether the power module is flush with the edge of the opening of
the rear panel. If it is, continue the operation. Otherwise the module may be damaged.
Install the empty power module slot with an empty barrier or power module.
The power supply socket should be installed near the device for convenient plugging.
Installing Fan Tray Module
Installing Router Fan Tray Module
This part applies to the installation of the RSR30 series routers. The module to be installed is the
RG-RSRXX40-FAN fan tray module.
1)
Place the router in such a way that you face the rear panel of its host.
2)
Remove the empty barrier on the slot where the fan tray module is to be installed.
