·
The socket-outlet shall be installed near the equipment and shall be easily.
When installing the unit, always make the ground connection first and disconnect it last.
The cross-sectional area of protective earthing conductor shall be at least 2.5 mm
2
(12AWG).
4.8 Installing Power Supplies
The RG-S7808C series switches provide AC power supplies including RG-PA1600I-F and RG-PA600I-F, and PoE power supplies
including RG-PA3000I-PLand RG-PA1600I-PL. Before performing the following procedures, wear an anti-static wrist trap close to your
kin and keep it grounded.
The RG-S7808C power system provides
four power supply slots and two PoE power slots. It is recommended that you
configure
1+1
power supply redundancy.
When RG-
S7808C
is powered up by more than one source, the power must be in the same model.
If you want to carry or lift the power module, please hold the bottom of the module with your hand instead of carrying the module
by the handle. Otherwise, the module may be damaged.
Before inserting or removing the power module, please verify whether the switch is well mounted. The switch is high, avoid switch
tumble when you are inserting or removing the power module.
If you want to hot swap a power supply, please make sure that the interval between two operation is greater than 30s.
Please do not touch the golden finger part of the power supply which is removed after power off in case that capacitor discharge
is not full.
Install the AC power system
1.
Loosen the captive screws on the fake panel covering the power slot at the rear of the chassis.
2. Insert the power module into the slot along the rail until the rear connector of the power module stays in good contact with the rear
panel.
3. Tighten the captive screws on the power module to fix it.
Figure 4-10 Installing AC Power Supplies
Install the PoE power system
The PoE power system shares the same installation steps with the AC power system.
The total power of power supplies of the RG-S7808C must be greater than the working power of the host. Otherwise, some
modules may fail to start.
