·
4.5 Mounting Cable Management Bracket
Make sure the antistatic wrist strap is grounded well and wear the antistatic wrist strap.
The cable management bracket of RG-S7808C is mounted before delivery
Mount cable management brackets for RG-S7808C
1. Take out cable management brackets.
2. There are six cable management brackets on each side respectively. Make sure the cable management brackets are mounted
properly, as shown in figure 4-6.
3. Align the screw holes on the cable management brackets with those on the chassis and tighten the screws, as shown in figure
4-6.
Figure 4-6 Mounting Cable Management Brackets for RG-S7808C
4.6 Mounting the Switch to a Cabinet
Precautions
Before mounting RG-S7808C series to the cabinet, first verify that the front and back brackets of the cabinet are at the right locations.
If the bracket is too far forward, the front panel of the equipment may be too close to the front door, so that the front door cannot be
closed when network cables and fibers are connected. Usually, you should reserve at least 10 mm between the front panel of the
switch and the front door of the cabinet. Before mounting the switch to a cabinet, you need to meet the following conditions:
Fasten the cabinet.
Insert various modules in the frame properly.
Remove any obstacle in the frame and the surrounding environment.
Prepare the equipment and move it to the place near the cabinet where you can handle it easily.
