RDLC320 Controller User Manual
30 / 45
© 2016 Ruida Technology. All Rights Reserved.
three interfaces, press the Left and Right keys to move X axis and press the Up and
Down keys to move Y axis. If the inching distance is set at 0, the moving time means
the time of pressing this key, which means that movement starts after the one of the
keys is pressed and movement stops after the keys are released. Where the inching
distance is not 0, the corresponding axis will move for the corresponding inching
distance after one of the directional keys is pressed once. In the movement processing
the speed can be increased or reduced automatically in order to reach the
maximum/minimum coordinates. The maximum speed of key movement is the speed
value set on the keyboard when the system lies idle.
After the polarity of directional signal for each axle of the machine
is adjusted well, if you press the Left key and the X axle will move
rightward; and if you press the Up key and the Y axle will move
down, which mean the key polarity of the axles moving to the
opposite direction is not right. In such a case you should modify the
key polarity of this axle.
(12) Fn key (Function key) in the middle of directional keys
The Fn key can be pressed when the system is idle or the work is finished. On
pressing this key, it will show three pages and nine entries in the following interface:
Z-axle Move
Axles Reset+
Inch
Laser
Fn
Figure: 8.2-8
Prompt
Origin
Set to Default Para.
Load Default Para.
Auto Focusing
Figure: 8.2-9
