RDLC320 Controller User Manual
24 / 45
© 2016 Ruida Technology. All Rights Reserved.
On any interfaces, press the Reset key (or when the system is powered) and the
controller will be reset. The machine will seek for the origin (configured according to
the user’s parameters through start-up and reset) and show the “Reset-in-progress”
prompted in the interface. The machine having successfully returned to the origin, the
laser head will automatically move to the setpoint set last time. If the last processing
is successfully completed prior to the resetting, the system will at this time return to
the interface in Figure 8.1-1; if the last processing is not completed (i.e. the power
supply is cut off during the processing), the system will at this time show as follows:
Pressing the “Esc” key in this interface and this de-energizing for continuous
engraving will be cancelled and the system return to the interface in Figure 8.1-1. If
processing was once started, the figure uncompleted in the former processing can’t be
de-energized for continuous engraving; if the “Enter” key is pressed in this interface,
the de-energizing for continuous engraving can be started in order to process such a
figure continuously.
After the de-energizing for continuous engraving is started, the
interface will show “Looking for cutoff point, please wait”. The
waiting time has something to do with the data size of last
processing. The larger the data size is, the longer the search for the
cutoff point by the controller is. Generally speaking, if the power is
cut off after the figure processing of one hour, the time that the
controller looks for the cutoff point is approximately one minute
when the de-energizing for continuous engraving is started after it is
powered next time.
(2) Laser key
On the system idle interface, the work finished interface, the system paused
interface and the interface to prompt whether to de-energize for continuous engraving,
press the “Laser” key and the laser outputs on the bursting. The time of open laser
may be set. If the time is set to zero, then the outputting time is the time when the
“Laser” key is pressed, that is to say, press this key for outputting and release it for
Whether to Power-off restart?
Yes to “Enter”
No to “Esc”
Figure: 8.2-1
Prompt
Laser