8
2
Safety
2.1 General
This operating manual provides important information concerning operation and maintenance
of the installation that must be observed. Authorised personnel/the operator must read the
manual carefully before going into operation and the manual must be kept in direct proximity
of the installation.
2.2 Qualification and training personnel
Any work on the compressor such as operation and maintenance shall only be carried out by
authorised, skilled and qualified personnel, who are familiar with the applicable safety
regulations. Repairs, maintenance and conversion work shall only be carried out by
authorised personnel.
2.3 Operating safety conscious
Essential safety regulations relating to the setting up, operation and maintenance of air
compressors are covered by the following publications:
- Regulations for the prevention of accidents, in particular:
• VBG 16 compressors
- Standards, in particular:
• DIN EN 12100 Safety of machines
• DIN EN 1012-1 Compressors and vacuum pumps, safety requirements
The latest edition of each of these regulations shall be applicable. Any special official codes
and regulations, particularly safety regulations applicable to your operation in view of the
local conditions shall be observed likewise. In the event of competing regulations, the most
severe requirements shall apply.
2.4 Safety instructions operator
Securing the compressor’s operational safety is the responsibility of the operator. Damaged
or non-functioning parts must be replaced immediately. If combustible materials are to be
handled by the compressor, it shall be ensured that the spontaneous-ignition temperature of
any dust/air mixture will not be reached. VBG 16 prescribes that a temperature limit of max.
120°C should not be exceeded (measuring point prior to contact with the conveyed product).
2.5 Modifications and repairing spare parts
Unauthorized repair work and modifications are not permitted. Warranty doesn’t apply to
installations with a damaged seal. Original spare parts and accessories approved by the
manufacturer contribute to safety. Using foreign spare parts and accessories may entail the
loss of any liability for the consequences arising therefrom.
2.6 Modifications installation
Without approval from RTI, it is not permitted to make any alterations to the installation.
