R.T.A. s.r.l. – XPETME05 – 11/20
5/29
In these cases, the person responsible of the installation must design and provide specific
equipments or safety techniques, external and independent from the drive, suitable to prevent all
dangerous consequences.
Use in conditions not complying with one or more specific limitations or prescriptions stated in this
manual regarding electrical, mechanical and environmental specifications or characteristics is strictly
forbidden.
2.4 -
CAUTION!
All products considered in this manual are sub-assemblies without a direct function, foreseen to be
integrated in a more complex machine. Only a professional assembler, expert in the field of motor
drives and in their related problems, can install and put in service this component
. It is exclusive
responsibility of the designer of the complete machine or installation in which this
component is used to take care of the safety and reliability of his project.
It is forbidden to use
this material in application covered from one or more EEC directives (for instance 2014/30/CE,
2006/42/CE, etc.) before the conformity to those directives has been declared. Regarding
2014/30/CE directive, see chapter 10.
2.5 -
CAUTION!
Suitable for use on a circuit capable of delivering not more than 5000 A rms symmetrical amperes,
230 Volts maximum; overvoltage category III. Overvoltage category IV is not permitted.
2.6 -
CAUTION!
Remote overload protection is required. Integral solid state short circuit protection does not provide
branch circuit protection. Branch circuit protection must be provided in accordance with National
Electrical Code and any additional local code] (see Fig. 7 chapter 7).
[The drive does not provide Motor Overload protection. External or remote Motor Overload protection
shall be provided in the end-use applications]. [The drive does not provide motor over-temperature
sensing. It shall be provided in the end-use applications].
It is exclusive responsibility of the designer of the complete machine or installation in which this
component is used to take care of the safety and reliability of his project.
2.7 -
CAUTION!
The drive and related motor have a protective earth terminal which must be connected to earth, in
order to prevent risk of electric shock.
2.8 -
CAUTION!
With the drive switched on, do not perform any wiring, maintenance, inspection; in particular, do not
perform the setting of the dip-switches. After switching the power off, wait at least 10 minutes before
to fulfill these tasks.
Do not touch the inside of the drive and do not get close to connection terminals while the device is
powered on.
Do not plug or unplug the connectors while the device is powered on. These operations cause some
underhand damages of the contact surface which could bring to a subsequent risk of overheating
and fire.
2.9 -
CAUTION!
Do not try to repair a faulty device. Only R.T.A. personnel is authorized to repair operation.
2.10 -
CAUTION!
During normal working conditions, the heatsink can reach temperatures until 80°C ( 176 °F). Do not
touch this component for some minutes, after switching off, in order to avoid scald hazard.
2.11 -
CAUTION!
EtherCAT commands used to switch off the drive output power and internal electronic functional
protections use semiconductor devices; they cannot be used to interrupt power in emergency stop
function or in any function involving personnel safety.
