MEMS Digital Inclinometer System with Android
Instruction Manual
ICM0099A
11
Table 1 Battery status LED
LED Flash
Battery Status
1 flash, reel does not power on
Battery completely discharged
2 flashes, reel does not power on
Battery discharged below level required to connect
1 flash, reel powers on
Battery discharged below 25%
2 flashes, reel powers on
Battery discharged below 50%
3 flashes, reel powers on
Battery discharged below 75%
4 flashes, reel powers on
Battery is at full charge.
C
HARGING THE
B
ATTERY
(
FOR REELS WITH SERIAL NUMBER OF
2500
OR HIGHER
)
Note
Refer to Appendix A if the reel serial number is under 2500
. Do
not
proceed with the
following instructions if the reel serial number is under 2500.
The following instructions are for reels with serial numbers of 2500 or higher.
The battery will need to be recharged using the provided charger. The battery port may be
accessed by unscrewing the cap on the outside of the reel. Refer to Figure 7 for the location
of the battery cap.
Figure 7
– Unscrewing the Battery Cap
Unscrew the battery cap by turning it counter clockwise. The charger will plug into the port
and begin charging the battery. Replace and tighten the cap when the charger is not in use
to ensure debris does not enter the battery port.
W
IRELESS
C
OMMUNICATION
Turn on the power to the reel by pressing the button located to the left of the battery housing
on the Reel Hub (Figure 7). A solid green light indicates the reel has been powered on.
After turning on the power to the reel, it automatically broadcasts its device name and will
continue to broadcast for up to 5 minutes. During this 5-minute window, the Digital
Inclinometer app must establish a Bluetooth connection with the reel. If the Reel Hub is
unable to connect to the Digital Inclinometer app, the Reel Hub powers down to reduce
battery consumption.
