Documenting Multifunction Calibrator / EN
12
06/04/2018 Version No. 1
Remark:
1.
Users are allowed to type in max. 5 digits.
2.
Type in a current value (including decimal point), press ENTER, then the
calibrator will output this current value.
3.
When the output value is <0, please type in a negative sign first.
4.
When the output value is <1 and >0,
please type in “0.” first.
Warning:
1.
Do not make an input or connect any charged installment to SOURCE
(terminals) to prevent from damaging the calibrator.
2.
When there is an output open circuit or overload, the calibrator can not
output the correct current. Please remove connecting leads and check when
there is a symbol of OUTPUT ERROR.
3.
Perform one function at a time and make connection to the specific
terminals only. Remove all other connections to the unused terminals.
Always connect to only one of SOURCE , MEASURE , or TC alone.
2b. How to set up
(1) Press
to enter SETUP function.
(2) mA 0%: set up the
“starting” current for scanning.
(refer to SCANNING chapter).
(3) mA 100%: set up the
“ending” current for scanning.
(refer to SCANNING chapter).
(4) 4mA
: set up the mapping unit for 4mA.
(5) 20mA
: set up the mapping unit for 20mA.
(6) MAPPING: here users can decide if they want MAPPING function.
(7) OUTPUT MODE: Current output modes switched to SOURCE or
SIMULATE.
(8) HART250: HART
TM
mode Enabled or Disabled.