A
3
2
1
4
5
A
C
B
3
4
1
5
2
ENGLISH
(See Fabric, Thread and Needle Table on page 23).
You may need to remove the presser foot holder to use
some presser feet.
To remove, raise the presser foot lifter and loosen the
presser foot thumb screw (C).
To attach, tighten the screw after raising the presser foot
holder.
Do not use any bent or dull needles.
REMOVING THE PRESSER FOOT HOLDER
INSERTING THE NEEDLE
Select a needle of the right type and size for the fabric to be sewn.
CAUTION:To prevent accidents.
Turn OFF the power before removing the needle.
1. Turn the handwheel toward you until the
needle is at its highest position.
2. Loosen the needle clamp screw.
3. Remove the needle.
4. Insert new needle into needle clamp with
the flat side to the back and push the needle
into the clamp until it reaches stopper.
5. Tighten the needle clamp screw.
A. Place needle on a flat surface and check
to see if bent.
A
Presser foot pin
B
Presser foot holder slot
C
Presser foot thumb screw
B
A
The presser foot must be changed according to the
or stitch you sew.
sewing job
CAUTION:To prevent accidents.
Turn OFF the power switch before you change the presser foot.
1. Turn the handwheel toward you until the
needle is at its highest position.
2. Raise the presser foot lifter.
3. Remove the presser foot by pushing the
presser foot release lever toward you.
4. Place desired foot with its pin
directly under
the slot
in presser foot holder.
5. Lower the presser foot lifter and the presser
foot will snap into place
CHANGING THE PRESSER FOOT
11
Summary of Contents for EVA 8700
Page 1: ...EVA Royal 8700 BRUGERVEJLEDNING INSTRUCTION MANUAL 1 ...
Page 2: ......
Page 3: ...DANSK DANSK ENGLISH ENGLISH 3 ...
Page 4: ...ENGLISH DANSK 4 ...
