![background image](http://html.mh-extra.com/html/royal/135dx/135dx_instruction-manual_1493971014.webp)
LOADING PAPER
__________________________________________________________________
HOW TO LOAD THE PAPER
This register uses standard 2 ¼ inch (57mm) single-ply bond paper to produce either a customer receipt (outside) or a journal
record (inside).
NOTE: It is recommended to use ROYAL brand 2 1/4" (57mm) bond paper, which will help prevent dust deposits on the printer
mechanism caused by inexpensive paper rolls. Replace with standard bond quality calculator paper.
ROYAL Part #013129
.
To order, call the Royal Supply Center toll free at
1-888-261-4555.
1. Plug in your cash register.
2. Grasp the printer cover by the finger tab on front, left side of the cover. Gently pull up on the front of the cover and
then raise it towards the back of the cash register (it is on a hinge and can be completely removed from the register).
(Figure E)
3. Cut or tear the end of the paper roll evenly for a straight edge to permit proper feeding through the print head.
4. Place the paper roll in the paper holder so that the paper will feed out from the bottom of the roll toward the front of the
register.
5. Insert the end of the paper roll into the paper slot (Figure F), the printer, under the black, plastic writing table.
6. Depress
the
[feed]
key until the paper catches and advances through the printer.
7. If the paper does not feed through the printer, make sure the paper has a smooth, straight edge and was inserted in the
proper slot.
8. Pass the tape through the receipt window of the printer cover, in front of the metal paper cutting blade, if a customer
receipt is desired.
or
If a journal record is desired, wind the tape around the black, plastic journal winder spool. Simply advance the tape
approximately 10-12 inches by using the paper feed
[feed]
key. Remove the left edge of the winder spool. Then, wrap the
beginning edge of the paper tape around the inner core or the winder spool and slide the tape under the two forks that
extend on both sides of the journal winder spool. (See Figure G). Turn the spindle manually a few times to take up the
excess paper. Replace the left edge of the journal winder spool and place the entire spool back into its holder towards the
back of the printer compartment. Then press the
[feed]
key until the journal paper tightens the paper securely around the
spindle. (Figure H)
9. Close the printer cover.
10