3.3. DEVICE USE
How to use
1.
Place a filled pot, etc. centrally on the hob.
2.
Connect the device to a power source and then turn
it on by pressing the On/Off button (not suitable for
RCIC-1000P9). The LED above the button will light
up (not suitable for the RCIC-3500P4, RCIC-5000
models).
3.
Set the temperature, heating power or timer values
according to the following descriptions for each
model:
RCIC-3500P4/RCIC-3500P5
•
Press the button (F) to set the heating setting.
Pressing the button (F) again will allow you to set the
heating temperature. Set the parameter value using
the buttons (C and E).
•
Press the button (B) to set the timer. Set the time
value using the buttons (C and E).
•
To lock the control panel, press the button (A) for 2
seconds. The lock concerns the (G) button. To unlock
the panel, press and hold button (A) for 2 seconds.
RCIC-1800P8
•
Press the button (B) to select one of the three
available functions: heating power, temperature or
timer. Set the parameter values using the buttons (C
and D).
RCIC-1000P9
•
To start the device, turn the knob from position 0 to
the desired temperature. It is not possible to set the
power and the timer.
RCIC-5000
•
Press the button (C) to select one of the two
functions: heating power or temperature. Set the
parameter values using the knob (D).
•
To lock the control panel, press the button (B) for
2 seconds until you hear a beep. The diode next to
the icon will light up. The lock does not apply to the
button (C). To unlock the panel, hold the button (B)
again for 2 seconds. After unlocking, the LED will turn
off.
The device will turn off automatically if no operation is
performed for 2 hours.
4.
If you want to stop the timer function, press the On /
Off button. Then press the On / Off button again to
turn the device on.
The devices are equipped with protection against
overheating. If the dish on the plate is too hot, the
device will cut off the power while sounding a signal and
displaying the message „E2“. Wait a few minutes until the
device cools down and restart.
Directions for use
a)
The cookware used with the device must be designed
for use on induction cookers and meet requirements
for the weight and dimensions associated with the
given device, i.e.
A.
Display
B.
Setting lock button
C.
ON/OFF button, function selection button (power,
temperature)
D.
Power setting knob
3.2. PREPARING FOR USE
APPLIANCE LOCATION
The temperature of environment must not be higher than
40°C and the relative humidity should be less than 85%.
Ensure good ventilation in the room in which the device
is being used. There should be at least 10 cm distance
between each side of the device and the wall or other
objects. The device should always be used when positioned
on an even, stable, clean, fireproof and dry surface, and
be out of the reach of children and persons with limited
mental and sensory functions. Position the device such that
you always have access to the power plug. The power cord
connected to the appliance must be properly grounded
and correspond to the technical details on the product
label.
A.
ON/OFF button with a LED
B.
Function selection button (power, temperature,
timer)
C.
Value decreasing button
D.
Value increasing button
E.
Display
RCIC-1000P9
The model has a display in the lower right corner of
a cooktop. The temperature is set by the knob on the back
of the product.
RCIC-5000
A
B
C
D
A.
Setting lock button
B.
Timer regulation button
C.
Value decreasing button
D.
Display
E.
Value increasing button
F.
Function selection button (power and temperature)
G.
ON/OFF button
RCIC-3500P5
A.
Setting lock button
B.
Timer regulation button
C.
Value decreasing button
D.
Display
E.
Value increasing button
F.
Heating power selection button
G.
ON/OFF button with a LED
RCIC-1800P8
1
2
1
2
1
2
1
2
1
2
RCIC-
3500P4
RCIC-
3500P5
RCIC-
1800P8
RCIC-
1000P9
RCIC-
5000
A
B
C
D
E
F
G
A
B
C
E
F
G
D
B
A
C
D
E
1.
Hob
2.
Control panel
Description of control panels
RCIC-3500P4
3. USE GUIDELINES
The device is designed for heating and cooking dishes
and liquids in cookware intended for use with induction
cookers. The product is intended for home use only!- not
suitable for RCIC-5000 (commercial use).
The user is liable for any damage resulting from
unintended use of the device.
3.1. DEVICE DESCRIPTION
ATTENTION!
Despite the safe design of the device
and its protective features, and despite the use of
additional elements protecting the operator, there is
still a slight risk of accident or injury when using the
device. Stay alert and use common sense when using
the device.
•
RCIC-3500P4 / RCIC-3500P5 / RCIC-1000P9 –
diameter Ø12 – Ø 26 cm and maximum weight 30 kg.
•
RCIC-1800P8 – diameter Ø12 – Ø 20 cm and
maximum weight 15 kg.
•
RCIC-5000 – diameter Ø14 – Ø 38 cm and maximum
weight 30 kg.
b)
The utensils and pots used must have a flat base.
c)
Hot pots must not be placed on a cold hob.
3.4. CLEANING AND MAINTENANCE
a)
Unplug the mains plug and allow the device to cool
completely before each cleaning, adjustment or
replacement of accessories, or if the device is not
being used.
b)
Use only non-corrosive cleaners to clean the surface.
c)
After cleaning the device, all parts should be dried
completely before using it again.
d)
Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
e)
Do not spray the device with a water jet or submerge
it in water.
f)
Do not allow water to get inside the device through
vents in the housing of the device.
g)
Clean the vents with a brush and compressed air.
h)
The device must be regularly inspected to check its
technical efficiency and spot any damage.
i)
Use a soft, damp cloth for cleaning.
j)
Do not use sharp and/or metal objects for cleaning
(e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
k)
Do not clean the device with an acidic substance,
agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage
the device.
DISPOSING OF USED DEVICES
Do not dispose of this device in municipal waste systems.
Hand it over to an electric and electrical device recycling
and collection point. Check the symbol on the product,
instruction manual and packaging. The plastics used to
construct the device can be recycled in accordance with
their markings. By choosing to recycle you are making
a significant contribution to the protection of our
environment. Contact local authorities for information on
your local recycling facility.
11
Rev. 24.05.2021
10
Rev. 24.05.2021
EN
EN
