1. Base
Prepare a level area for the gazebo to sit. Position the 6 floor bearers as shown in the diagram. Support the bearers at the centre using the square base plate and at the
outer end of each bearer using the rectangular base plates.
2. Floor bearer separators
Between each floor bearer position a floor bearer separator as shown below.
40mm
Square base plate
Rectangular base plate
Square base plate
Flat end floor bearer
Angled end floor bearer
Pointed end floor bearer
Angled end floor bearer
Flat end floor bearer
Pointed end floor bearer
Note:
So that minor
adjustments to the floor
bearer position can be
made, do not secure the
floor down at this stage.
3. Floor panels
Place onto the floor bearers the floor sections to complete the hexagonal shaped floor.With all the floor panels in place fit the hexagonal floor centre piece in the middle.
Do not fix the floor sections into place at this stage.
4. Upright posts
At each corner of the floor position the rebated end of an upright post between the pre-attached metal bracket of the floor bearers and the edge of the floor panel. Fix
the posts to the brackets using 4 x 40mm screws per post. Screw through the bracket into the post.
