-9-
Cylinder Cover Assembly
3
4
5
6
7
8
16
8. Look down the cylinder, notice there is a slot at the
bottom of the cylinder (
Fig. 26
). Insert the piston
blade gently, and make sure that the tip of the blade
fits inside the slot.
7. Make sure the new piston is clean. Apply lubricant
grease (
AS65
) to the disk part of the piston,
especially around the O-ring.
9. Make sure the entire cylinder cover assembly is intact,
all the parts are on, including compressed spring (3),
rectangle washer (4), cylinder cover (5), O-Rings (6 &
7), piston stop (8) and sealing gasket (16). Place the
cylinder cover assembly on as shown (
Fig. 28
).
10. Place the exhaust cap on as shown (
Fig. 29
).
11. Insert the four bolts. Tighten the bolts while
pressing down the exhaust cap. Connect the stapler
to the compressed air, and try to shoot a few staples.
Make sure there is no air leak.
Fig. 27
Fig. 25
Fig. 28
Fig. 29
Fig. 30
Grease here
Fig. 26
