-6-
How to Replace Pusher and Pusher Spring
With use, the pusher and pusher spring will be worn and
need to be replaced. Call Rowley Co. to order the parts.
1. Undo the screw (
Fig. 8
) and remove the L bracket
holding the magazine cover.
2. Press the magazine latch (
Fig. 9
) to slide the
magazine cover off the stapler.
Look closely inside the magazine cover slot, at the
nose end, there is a tension roller for the pusher
spring to go around. In the bottom of the magazine
cover slot there is a hook for hooking one end of the
pusher spring. Spring goes around the tension roller
and the other end of the pusher spring connects to
the hook on the pusher. See (
Fig. 10).
Spring Go Around
Tension Roller
Connect one
end of spring to
the Magazine
Cover Hook
Magazine Cover
Pusher Spring
Pusher
Pusher Hook
3. Thread the spring behind and around the tension
roller into the magazine cover slot (
Fig. 11
).
4. Connect one end of the spring to the hook on the
pusher (
Fig. 12
).
5. Use a straightened paper clip or a T-pin to pull the
other end of spring out of the magazine cover slot,
while firmly holding the pusher (
Fig. 13
).
Connect to
Pusher Hook
Repair and Maintenance Instructions:
Thread spring
around the
tension roller
Fig. 8
This end will be
connected to the
pusher in Step 4.
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
This end will be
connected to
magazine cover slot
hook in Step 6.
