2015-2017 5.0L Mustang Phase 1/2 RHD ROUSHcharger Kit
SECTION B – MODIFICATIONS
1316-RHD-AA 12152016
46
800.59.ROUSH
KNOCK SENSOR ORIENTATION
ADJUSTMENT
The knock sensors must be reoriented and the
harnesses rewrapped to accommodate the new fuel
charging assembly. It will be necessary to split the
two (2) sensor wires further up the harness in order to
gain the necessary slack for proper sensor positioning
towards the side of the engine valley.
1. Remove the 90-degree plastic wiring retainer
clipped to the connector and taped to the wiring
convolute.
2. Loosen the two (2) bolts which retain the knock
sensors to the engine block (10 mm socket). If
necessary, one (1) of the bolts and sensors can be
removed for this modifi cation process.
3. Peel back the tape from the connectors and
remove the convolute approximately 1-1/2" past
where they meet at the harness.
4. Temporarily
fi t the sensors as follows to determine
where to rewrap the wires. Install and rotate the
RH and LH knock sensors as far as possible to
the outside of the valley of the block. Check that
the sensors lay low on the engine valley so they
will not interfere with the fuel charging assembly
once it is installed.
5. Reinstall the convolute and rewrap the wires with
electrical tape as required.
