ROUND Pools AMBASSADOR, Installation Manual

Page: 29 / 40

7
No Diving or Jumping. Observe all Safety Rules.
3-7
3-5
Remember:
Do not
trim off the
excess liner. (If the liner
ever needs to be removed,
trimming the liner will
make re-installation very
difficult.) Instead, roll up
any excess liner and tape it
in place near the top of the
pool wall.
3. Fasten the Liner in place (Hung/J or V-Bead Liner only)
a. With a V-Bead liner you will not
use the plastic coping strips that are
packed in the parts carton of your
pool. You can discard those pieces,
if they are included, as they only ap-
ply to pools with overlap liners.
b. The top of the wall of the liner has
what is called a “V-Bead” welded
onto it. Simply open up the bead
with your fingers and hang it directly
on top of the pool wall. When this
is done properly, the only portion on
the outside of the pool wall is ap-
proximately 1” of the V-Bead. No
printed liner material is actually
going over the top of the wall to the
outside of the wall.
c. Make sure the bead is on evenly
around the entire pool, and that the
liner is hanging straight down from
the top of the wall. The liner should
not have creases in it because it is
twisting around the pool. If the liner
is twisting, it is because it is not
sitting properly in the pool. Make
necessary adjustments before pro-
ceeding.
NOTE: Some liners may fit very tightly,
it is better to install uprights, top
plate and top ledge before going onto
next step. See Section 4.
21
21