ROUND Pools AMBASSADOR, Installation Manual

Page: 21 / 40

No Diving or Jumping. Observe all Safety Rules.
2-1
REMEMBER:
Spread stabilizer out over
the entire pool foundation
area inside the base rails.
This pro-vides a protective
surface for the pool liner to
rest on.
HINT:
Bend the first 1/8" (3 mm)
of the end of the bottom
rail slightly with a pair of
pliers to make sure the rail
doesn’t slide out of the base
plate when the pool wall is
installed..
NOTE:
If you want, in-stead of
using pa-tio stones you can
make crushed lime-stone
pads. Dig a 12" x 12" (30
x 30 cm) square hole 2" (5
cm) deep and fill the hole
with sta-bilizer, packing it
down hard. Spray with wa-
ter as you pack it down. .
A. Assemble your Pool Base
1. Lay out the Base Plates and Bottom Rails
a. Place the base plates equally spaced around the perimeter of your foun-dation. If you are
using the optional patio stones, place one base plate on each stone..
b. Slide the curved bottom rails together
with the base plates. Leave a 1/2"
(13mm) gap between the ends of the
bottom rails.
NOTE: Please refer to your pool's footprint
(See Section 1, last page) for the gap
measurement for your pool size.
2. Spread out Brick Sand/Stabilizer
a. Spread a layer of fine brick sand (no
pebbles) over the foundation area, 2"
(5cm) deep. Use a rake to make the
brick sand flat and smooth..
S
ection
Pool Component Installation Manual
Assembling the Pool Base
2
1
3
2
4
see footprint chart for
gap measurement