ROUND Pools AMBASSADOR, Installation Manual

Page: 37 / 40

5
No Diving or Jumping. Observe all Safety Rules.
4-5
d. Push the lower part of the connector in towards the vertical column and line up the
two screw holes in the lower portion of the connector with the two holes in the vertical
column. Fasten the connector in place with two self-tapping screws (key 3). Important:
Tighten the screws
only
until a snug fit is obtained.
Do not over-tighten.
e. For oval pools only: At the transition points only, where the end rail meets the side
rail, make sure the side rail lines up properly with the end rail. If it doesn’t line up,
the connector will appear crooked from above (see diagram 12). If the connector isn’t
centered between the rails, temporarily remove the connector and loosen the screws
on the side rail. Shift the side rail in or out from the center of the pool until the con-
nector can be properly centered between the rails (see diagram 13).
f. Install either a connector clip or hook (key
10) in the following manner: Insert the large
center tab & two smaller tabs located at the
top of each into the openings located at the
top of the clip housing in the connector.
Rotate the bottom of the clip or hook into
the housing and press firmly at the bottom
of the clip or hook until a snap is heard (see
diagrams 14 to 15). If the connector clip or
hook does not snap in, slightly loosen the
screws.
g. First insert the tab on the left of the logo
insert (key 11) into the opening on the
top of the connector designed for the logo
insert. Bend the insert slightly
and insert the other tab into the
opening on the other side of the
connector. Press down on the
insert to ensure a proper fit.
h. Repeat the last seven steps for
the rest of the top connectors.
Caution:
Be sure to
spread the
sides of the lower
half connector
before
stretching it across the
top rails or the connec-
tor may be damaged.
14
15
10
10
11
11
12
13
11
3
Note:
If necessary, the plug
covering the screws can
be removed by prying
it out with a knife. Be
careful not to damage
the edges of the plug.
t