2
No Diving or Jumping.
Observe all Safety Rules.
3-2
Remember:
The bolt heads must be
toward the inside of the
pool. Cover the bolt heads
with duct tape.
Hint:
Stick a screwdriver
through two of the holes
to help line up the ends of
the wall.
5
6
8
e. Work around the foundation until the entire pool wall is uncoiled into the bottom
rails and the top edge is covered with the omega stabilizer and connectors (and
beaded liner retainers if you have a beaded pool liner).
2. Join the Ends of the Pool Wall
a. Line up the holes in the two ends of
the pool wall.
b. To line up the holes, make the circle bigger or smaller by
nudging the bottom plates in or out with your foot.
You
MUST
recheck the gaps at each and every one of the
bottom rails so that they are all equal in gap size.
c. To fasten the wall joint, overlap the
two steel bars, one on the inside and
the other on the outside. Tighten the
mechanical screws on the inside and
the nuts on the outside.
NOTE:
When tightening the screws
start from either the top and go down
or vice versa. do not start a few
screws from top and a few from the
bottom to meet in the middle, this
can cause problems later on.
d. Ensure that all bolts and all the holes
are used.
e. Cover the seam and bolt heads on the
inside of the pool wall completely
with three layers of 2" (50mm) duct
tape.
Important:
Bottom rails must always
be held in place by the bot-
tom plate.
7
Summary of Contents for AMBASSADOR
