1.
Remove the 2 push pin clips on each side of the fender well trim, use an auto trim puller.
See Photo 1 and 2.
Save hardware.
2.
Starting at the bottom, pull the fender well trim out releasing the clips, use care not to brake any of the clips off of the
trim.
See Photo 3.
Repeat this step on the opposite side of the vehicle.
3.
Remove the bolt from each side of the top of the grille support, use a 10mm wrench.
See Photo 4.
Save hardware.
4.
Using an auto trim puller, remove the push pins from the top of the grille support.
See Photo 5.
Save hardware.
5.
Remove the 2 bolts in the rear of the skid plate, using a 14mm socket.
See Photo 6.
Save hardware.
INSTALLATION INSTRUCTONS
Photo 1
Photo 2
Photo 3
Photo 4
Photo 5
Photo 6
Remove the push pin clips.
Remove push pin clips from each side.
Remove the fender well trim.
Remove the top 2 bolts.
Remove the push pins.
Remove the lower skid plate bolts.
Summary of Contents for JEEP 2017-19 WK2
Page 11: ......
