Rottler SG10A, Operation And Maintenance Manual

Page: 52 / 124

Section 5 Operating Instructions SG10A Manual
www.rottlermfg.com
5-6
Lightly tighten the lock levers on the supports to remove any play. Now tighten the clamp on the fine
adjustment screw. Turn the adjustment knob to achieve the exact reading that was observed on the
leveling post. You can now completely tighten both the left and right support locks.
Left to Right Alignment
Obtain the left to right reading from a pilot mounted in a guide in the cylinder head. Now place the level on
the leveling post . Loosen both of the tilt lock levers on each side of the quill housing. Use the tilt adjusting
hand wheel to adjust the reading to be the same as that found on the pilot in the cylinder head. Tighten
the tilt lock levers.
Canted Valve Cylinder Heads (Automotive Application)
An optional alignment bar is available that helps establish the front to back alignment on canted valve
cylinder heads. The bar is held against two pilots in two adjacent guides. Use the alignment post to adjust
the angle. (See Picture)
NOTE: It is important that the operator of the SG10A read the Control Definitions chapter in this
manual before proceeding any further.