2.02 - Starting and Stopping
1. Be sure that no one is near the machine prior to engaging or while the machine
is working.
2. Be sure the tractor is in "Neutral" before starting engine.
3. Mower operating power is supplied from tractor PTO. Refer to your tractor
manual for PTO engagement and disengagement instructions. Always operate
PTO at 540 rpm. Know how to stop the tractor and mower quickly in case of an
emergency.
4. When engaging PTO, the engine rpm should always be low. Once engaged and
ready to start cutting, raise PTO speed to 540 rpm and maintain throughout
cutting operation.
5. Check the tractor master shield over the PTO stub shaft. Make sure it is in good
condition and fastened securely to the tractor. Purchase a new shield if old shield
is damaged or missing.
6. After striking an obstacle, disengage the PTO, shut the tractor down and
thoroughly inspect for damage before restarting.
7. Never engage the PTO until the mower is in the down position and resting on the
ground. Never raise the mower until all blades have come to a complete stop.
2.03 - Messages and Signs
1. Read and adhere to all safety and operating decals on this machine
(see fig. 2)
.
2. Before dismounting tractor: allow moving parts to stop, stop engine, set brake
and remove the key of unattended equipment.
3. Keep away from rotating blades and driveline.
4. Keep guards and shields in place and in good condition.
5. Do not mow with bystanders in area.
6. Allow no riders on tractor or mower.
7. Allow moving parts to stop before repair.
8. Securely support mower before working underneath.
Additional warning and operating decals are available at no extra charge. Please
specify model and serial number when ordering.
OPERATOR'S MANUAL
CYCLONE 'C50'
ROTOMEC
8
GENERAL INFORMATION