14. Never replace hex bolts with less than grade five bolts unless otherwise
specified, i.e. shear bolts
14
.
15. When the machine is not hooked to the tractor, the driveline must be supported
by the storage hook to the top link.
16. Where replacement parts are necessary for periodic maintenance and servicing,
genuine replacement parts must be used to restore your equipment to original
specifications. The company will not claim responsibility for use of unapproved
parts and/or accessories and other damages as a result of their use.
17. Unauthorised modifications to the machine may impair the function and/or safety
of the machine and reduce its life. If equipment has been altered in any way from
original design, the manufacturer does not accept any liability for injury or
warranty.
4.02 - Service
The accompanying illustrations show lubrication points. The chart gives the frequency
of lubrication in hours, based on normal operating conditions. Severe or unusual condi-
tions may require more frequent lubrication.
Use a good quality SAE multi-purpose type grease for all locations shown. Be sure to
clean fittings thoroughly before using grease gun.
Use 90 wt. or 140 wt. gear oil in gearbox.
Hourly:
1. check the condition of mower blades for nicks or dull edges. Sharpen if
necessary.
OPERATOR'S MANUAL
CYCLONE 'C50'
ROTOMEC
22
GENERAL INFORMATION
14
Refer to table 1 - Torque Specifications, for head identification marking.
Fig. 8 - Lubrication of caster wheels and wheel yokes.