Be sure all wheel arms are adjusted equally. This is the only way to ensure a
completely uniform cut.
IMPORTANT: very low cutting heights should be avoided. Damaging shock loads
occur when the blades strike the ground repeatedly. This can cause damage to
the mower.
Cutting lower than 5 cm. (2") under most circumstances should be avoided.
The cutting height is adjustable from 25 to 125 mm. (1" to 5").
A front anti-scalp roller is also available upon request
6
. This accessory is particularly
helpful when cutting over uneven terrain.
3.04 - Pre-Operational Check
Check each of the following, carefully, prior to engaging the equipment:
1. the spindle bearings have been greased.
2. The belts for proper tension.
3. The oil in the gearbox.
4. The driveline cross & bearings have been greased.
5. No wrappings or foreign objects are around the blades, belts or driveline.
6. The blades are properly installed and the blade bolts properly torqued
7
.
7. All hardware is tight.
8. The tractor, to ensure correct direction of PTO and rpm speed.
9. All safety shields and guards are in place and tightly attached.
10. No people or animals are in the work area.
OPERATOR'S MANUAL
CYCLONE 'C50'
ROTOMEC
14
GENERAL INFORMATION
7
See table 1, page 29.
6
On model C50-210RD the anti-scalp roller is standard equipment.
Fig. 5
The cutting height is
adjusted by moving
the height adjustment
spacers on the wheel
yokes above or below
the wheel arm.