8.2.3 Calibrating the hand-held transmitter
PRECONDITION
The following is required to calibrate a hand-held transmitter:
■
Use a thin stick with a max. diameter of 3 mm to actuate the calibration push-button on the Eneo C |
CC | CF
■
Hand-held transmitter
■
Eneo C | CC | CF
■
Compatible key for the cylinder
1. Unlock and open the door.
2. With the door open, lock the lock using the key.
3. Press the radio calibration push-button [1] on the
Eneo C | CC | CF.
A sequence of sounds lasting up to 18 seconds is
heard.
Eneo C | CC | CF is in calibration mode.
1
4. Activate the hand-held transmitter (within
18 seconds).
Once Eneo C | CC | CF has detected the signal
from the hand-held transmitter, at this point it
stops the sequence of sounds and confirms the
detected signal with a beep lasting 2 seconds.
Eneo C | CC | CF exits calibration mode automati-
cally.
5. If you need to calibrate additional hand-held trans-
mitters, repeat steps 3 and 4.
6. Eneo C
Unlock the lock using the key and lock close the
door.
Turn the key as far as it will go (around two full
turns) and then remove it.
Commissioning and operation
Hand-held transmitter
Calibrating the hand-held transmitter
72 ·
05 / 2020
·
IMO_438_EN_v3
Roto Safe E Eneo C | CC | CF
Subject to change.
