Roto-Mix 425, Operator'S Manual

Page: 32 / 92

SCALE MOUNTING (TRUCK MOUNT
ONLY)
The primary scale indicator is mounted to the right
hand side of the driver seat on an adjustable pedestal.
The pedestal is custom fit to the truck and is bolted to
the floor of the cab and supported with braces to avoid
vibration. The pedestal can be adjusted as shown in
Figure 16 to provide easy viewing and access from the
drivers seat.
Auxiliary indicator mounts are also supplied on the
right and left hand side of the mixer to provide for
mounting of an optional Remote Indicator on either or
both sides of the mixer. These mounts allow the indi-
cator to be rotated for easy viewing.
The Truck mixer is initially provided with mounting
brackets matching the scale indicator purchased. If in
the future a different scale indicator is purchased, new
mounting brackets will be needed.
CLEARANCE LIGHTS (TRUCK MOUNT
ONLY)
Rear mixer mounted clearance lights and bunk spot
lights are optional equipment on truck mounted mixers.
The rear clearance light and rear bunk light are
mounted to a full width light bar which mounts to the
mixer using existing Tuff Glide Extension mounting
holes. The front bunk light mounted above the con-
veyer area and the front clearance lights mounted on
the front corners of the mixer are attached using sup-
plied brackets and the existing Tuff Glide Extension
mounting holes. All wiring runs through supplied con-
duits running along the top left edge of the mixer and
down along the back edge of the mixer to the truck
frame.
The front and rear clearance lights are wired directly
into the truck light wiring and are turned on and off with
the truck's lights. The bunk lights are wired to the
switch box supplied with the mixer and are turned on
and off using the switch marked "Lights".
Page 32
FIGURE 16. SCALE INDICATOR
AROUND ADJUSTING
BOLT
IN/OUT
ADJUSTING BOLT
UP/DOWN
ADJUSTING
BOLT