11
Parking Sensor System
Plastic bumpers do not require the rubber
sleeves included in kit.
Metal bumpers require the 24.5mm drill. Metal
bumpers require rubber sleeves installed before
installing sensors. (Note: The rubber sleeves
must be oriented with "UP" notation mounted
up).
Sensors can be re-painted to match the color of
your vehicle. Note: The painting layer must be
symmetrical and less than 0.1mm (.004 in.)
thick.
Under-Bumper Installation Steps
·
Mark the positions of each sensor below the bumper
with a marker to ensure proper location.
·
Mount brackets using the supplied hardware.
Note: Brackets must be mounted to ensure the center
axis of the sensor is parallel to the center line of the
vehicle and perpendicular to the ground.
·
Insert the rubber sleeves into the brackets.
·
Insert the sensor cables into the holes made in
bumper according to serial number. Refer to Fig.2
Powering Up
Power connections of reverse parking system
The control module gets power from the reverse light circuit
of the vehicle. Refer to Fig.15.
It is recommended to solder all connections. If it is not
possible to solder the connections, use the supplied
Summary of Contents for Park-Pro HD
Page 1: ...Form 5299 Rev B 07 27 12...
