10
Parking Sensor System
Area behind sensor must be open and not contact sensor
body (bumper, mounting brackets, foam…etc .).
The face of the sensor should be perpendicular to the
ground. If the bumper surface is angled, use the supplied
angled bezels to compensate.
Note: To use angled bezels, first, carefully remove bezel
from sensor. Snap correct angled bezel on sensor with bezel
angle in proper orientation.
Horizontal and vertical positioning
See Fig.14, “L” is the width of vehicle. L1 is the horizontal
distance between sensors (L1=16”±2”). For a wider
detection angle, locate side sensors closer to the lateral
sides of the vehicle. L2 is the height of sensors
(L2=25”±5”).
Installation steps
·
Mark the positions of each sensor on bumper with a
marker to ensure proper location.
·
Drill holes using the included hole saw. (An M2/.079”
drill bit can be used to drill pilot holes to aid in this
process.)
·
Remove the burrs from the hole edge with a file.
·
Insert the sensor cables into the holes made in
bumper according to serial number. Refer to Fig.2
IMPORTANT
Use correct hole saw. Sensors may not function
properly with holes that are too small or too large
in diameter.
Plastic bumpers require the 21.5mm hole saw.
Summary of Contents for Park-Pro HD
Page 1: ...Form 5299 Rev B 07 27 12...
