Programming Cards and Tags
CP-R25 Hardware & Software Manual
Page 23
keypads’ transmission format from the
Transmit Format
dropdown menu.
9. Enter the KeyA to be used by the reader as the unique
KeyA for the organization or site. Type the same value in
the
Reader KeyA
and the
Confirm Reader KeyA
fields.
Note:
The KeyA number is hidden by "*" characters, so write down
the new key and keep it in a safe place to avoid exposing
this secret key to unauthorized personnel. The KeyA value is
entered as a 12 hexadecimal digit with the format
FFFFFFFFFFFF.
10. Place a blank MIFARE card or a card previously configured
as a Configuration Card on the CP-R25 Desktop
Programmer antenna area.
11. Click
Start
to begin programming the MIFARE card.
On completion a message is displayed in the Message Log
area to verify that the programming succeeded.
If the programming is a failure there is a short buzz and the
swipe Card Reader LEDs lights red for three seconds.
5.3
Fingerprint Swipe Reader Configuration Cards
The Fingerprint Swipe reader configuration card allows the
creation of a configuration card, used to configure the various
Fingerprint Swipe readers such as the AY-B1663, AY-B3663, and
AY-B4663.
To Prepare Biometric Swipe Configuration Cards
1. Select
the
Swipe Reader
tab.
2. Select
the
applicable
Operation Mode
, either
Sector
or
Card Serial Number (CSN)
.
For
Sector
operation mode, define the
ID Location
using
the
Sector Number
,
Block Number
, and
Byte Number
fields.
3. Ensure that the
Operations
is set to
Program Card
.
4. From
the
Operation Type
dropdown menu, select
Program
configuration card
.
5. Select
the
Card Type
, either
Mifare 1 K
or
Mifare 4 K
.
